[Vehicle speed issue]

I asked in Race-Technology too and I'm waiting the answer. While, I ask here if anyone know something. Thank you Adamw. I used various cables and I have the same problem.

[Vehicle speed issue]

Finally I could go to the workshop and try it. The Dash is not Dash2Pro, is Dash2. Although the menu is similar, I have two problems:

1. When I connect the PC directly to the dash by a serial cable, if I want to read or send the configuration, after a few seconds, the software tell me that It's not possible to continue reading (sending)

2. When I want to change the data source for speed signal, I have this:

 

And when I go to CAN configuration, I have this:

However, although is this list doesn't appear any channel, on the dash' screen we see temperatures and pressures (that are connected to the ECU too, not to the Dash), so I'm a little confuse. It's the first time that I configure a system like that so sorry so much if there are many obvious solutions that I've not seen before.

Thank you very much for everything.

[Vehicle speed issue]

I'm going to try it. Thank you very much to everyone!!

[Vehicle speed issue]

Hi everyone!

I have just started to work with Link G4 ECU and Dash2 from Race yechnology and I have a problem with speed definition. I only have a wheel speed sensor that I installed in RR wheel. With it, in Chassis and Body menu, I fill the speed source as the image bellow shows. At this point is everything ok?

If the speed is well defined, the problem is when I send the information to the dash. The speed is not read. What could be the reason? 

Thank you very much for your help.