[4.4 v8 vdo bmw throttle body]

Looking for the pin diagram for the pedal! Can anybody help with this?? 

Thanks in advance. 

[4.4 v8 vdo bmw throttle body]

10 hours ago, Adamw said:

All of them that I have seen match the BMW M52 one in the help file.

Thanks for your reply! I have checked mine against this one pin numbers are slightly different! I will go ahead and wire this into the link! What about the 350z electronic pedal. How does this get wired I have never done electronic setup before now! Thanks again. 

[4.4 v8 vdo bmw throttle body]

14 minutes ago, Slowgti said:

Do you have a part number or know what the base car it came off?

Hi thanks for reply p.n is 1435959

[4.4 v8 vdo bmw throttle body]

Hi I have a dbw throttle body and nissan 350z electronic throttle! Iv tried looking on the wiring section in link to find some data to wire these in. I can't seem to find anything. Please can some1 help

[106 injection rate]

Firing order 1342 Peugeot 106 gti

[106 injection rate]

Maybe my trigger settings are wrong. I have a reference of 0 tdc and 267deg in my offset. The two teeth missing are bottom dead when engine cilynder 1 and 4 tdc. The sensor is approximately 90 degree atdc. So basically when my cells have 0 in it should be tdc 20 should be 20btdc someone please clear this up

[106 injection rate]

Ok guys iv spent all morning on multi point. 760 injection rate 1 cycle. It starts now and again but something just isn't rite!! Please help. Iv bypassed the efi relay and supplied voltage direct to items fuel pump/injectors/coils.pump on constant?

[106 injection rate]

Thanks Simon. Is this single point group or multi point?

And 720 end of injection or start? 

[106 injection rate]

I'm not sure! Hopefully moderator can help?

Iv been trying to use multi point on 1 cycle but with no luck! I'm looking for correct settings 

[106 injection rate]

Hi iv fitted storm ecu to boosted 106 gti.

I'm sure it runs batch fire and group injection.

It only has crank sensor.  Base timing set to 270 offset and 0 ref.  Injector 1 and 4 are wired together and so are 2 and 3 from standard.

Iv wired no 1 and 4 = inj drive 1 and 2 and 3 = inj drive 2. 

I'm using multi point group but iv also got it running on single point today. Injection rate is set to 540 but I don't think this is correct. Can someone please help. I know it injects out of faze but how far after?