-
Posts
21 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Kimple Fi
-
-
I can't start the engine now because the cylinder head is in the machining center. I'll try again later when I get the machine up and running
-
I have the latest Firmware and software too.
-
-
-
Ok
Thanks Adamw
-
Ok.
I have two kinds of instructions.
I try another .
Thanks
-
With candash cable 5wire.
Do i need to power the can lampda outside the ecu?
-
-
Hello everyone !
We load newest software and put ecu latest firmware. Connection ecu and laptop Works fine. When you assembly can-lambda, then connection lost. Have any same problem?
-
The problem is over. I don't know where the problem was, but now I'm getting in contact to ecu. I checked the programming cable and reinstalled it and now it works.
Thanks Adam for the quick response
-
Hello everyone!. I have a problem getting in touch with my ECU. I uploaded new firmware inside the box and now I can get contact the box. What can be done !?
Desperate
-
Thanks to you Simon
-
How i wiring ethanol sensor to my plug in g4+ toyota altezza sxe 200 ?
Thank you
-
Ok , thank you !
-
Hi everyone. I am replacing the original injectors (340cc) larger injectors(1600cc) .. What do I need to change the settings?.
-
Ok
Thanks to you Adam
Kimmo
-
Ok
Thanks Simon !
Can I use "vehicle speed input" (DI 3) for example, because this is left unused in my assembly ?
Kimmo
-
Hi guys !
Which pin must connect to the Launc Control , Altezza plug in g4+ ?
Sorry my English
Kimmo
-
Hi Adamw !
Thats help me . Thank you
Kimple Fi
-
Hi everyone ! . I have plug in altezza plug in G4+. I should know which wire connected to the "Start signal" pin ? (Digital input). Sorry my sadly English :(.
Can Lampda problem
in G4+
Posted
Because the next time I connect to the ECU, the can settings are zero. I guess the installation didn't work then !?