olivier

many thanks for your help laminar

hi, someone can tell me if all is right because my gear not change in plex display

i all, someone can help me about my gear detection and indicator on plex dash sdm 300? i sheck most times all the value in link gear and gear detection in plex but the gear indicator on dash don't run idear? best regards .pclr final map plex sdm300 v1 modif rpm .pdc

ok many thanks for all , i think i need to set up on the roller again

hi Adam, have you got a time to aswer me please? kind regards olivier

thanks Adamw sorry for my english, i just to know if the man who set up my car on the roller are mad a good job or not? also i m not VVT just 1 thoot on camshaft it's a focus rs mk1 engine zetec 2L turbo kind regards olivier

hi all, it's my MAP attached, someone can tell me if all are right? best regards G4+ Ford Fiesta WRC v1.1 modif ralenti 26-12-22.pclr

hi Adamw i fit the earth cable and the engine start slightly better, also look out to the new log, my battery shut down at 9.6volts, i think is not good thanks and merry christmas Log 2021-12-23 1;28;33 pm.llg

thanks Gavin i ll try it what you said

many thanks Adamw, i try this and be back

should I only keep the purple cable and take off the engine and battery eath? thanks

i m not direct cable between battery and engine block, look at the attachement there is my wiring, also i ve got an ODYSSEY 25 pc680 battery (520A during 5 seconds crancking). my battery cable size is 16mm2 best regards

ok good news about interference, i ve got toyota yaris multi coils and NGK pltr6a_10g regapped at 0.7mm. My battery is at foot passenger may be 0.8meters cable longer between battery and starter motor. i'll try to do triggerscope this week many thanks to help me

hi Adamw thanks to answer me this is a G4+storm for a focus RS 2004 engine ( zetec turbo) with coil pack and wosp 1.4kw starter motor, this log the engine crancking very well but sometimes when the engine it's hot it starts when i stop starter motor. Log 2021-07-11 10;50;12 am essai demarrage.llg

hi all i think i ve got an interference with my starter motor . the engine start when the stater motor stop to run, also someone know what value of filter can i fit on trigger to eliminate this problem? regards