I have done my best to search all of the previous posts, but I can't find a solution. Here's a rundown of my vehicle:
1991 Eagle Talon AWD Turbo
4G63T Engine
Link G4+ - VR4 Link
Wide-band: AEM 30-2301 Controller with a digital (non-controller) gauge, factory narrow-band has been removed.
I used a pin from a spare engine harness and attached the orange 0-5v out wire from the wideband controller. I removed the NB O2 pin from the main engine harness and inserted the modified pin into the connector. This should have the 0-5v signal from the AEM wideband going to AN Volt 4 on my VR4 Link ECU. At first I got error code 20: AN Volt low or at ground. I changed the settings so that the min and max are 0-5v, which took care of the error. I changed AN Volt 4 to display 0-5V and it shows 0.02V all the time. The wideband gauge is working just fine. I checked voltage at the harness pin and it read 4V with the O2 sensor disconnected, which is what the controller defaults to when the sensor is disconnected. That was with the harness disconnected from the ECU. I also removed the pin from the harness and check voltage at the pin with the engine running. It hovered above 4V and below 5V, which appeared to be consistent with what the wideband gauge was showing. I used a chassis ground with the multimeter when testing. I have tried attaching the wideband ground black wire and the brown differential ground wire to multiple ground locations (chassis, battery terminal, block), without any luck. I also tried all of those with the brown differential ground taped off. The reading in the ECU always stays at 0.02 V. The only test I have not completed is checking voltage of the ECU pin when the harness pin is attached. I do not have a good way of gaining access with multimeter to do this. I wanted to see if anyone has any insight on this before I pull the cover off of the ECU and attempt to test the ECU pin itself. I also compressed the harness pin just a bit to ensure it would make a good connection.