kelvin1982
-
Posts
23 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by kelvin1982
-
-
Hi Adamw, would you mind sending me how to turn in on for knock setting with stock knock sensor, now using the Evo1-3 g4+ plug in.
Thanks.
-
Hi Adams,
Thanks for your information.
-
Hi, I have one of Evo 3 running Link Evo 1-3 g4+ plug in.
Now I convert to COP with wasted spark mode and using Honda k20 coil.
So I need change the dweel time? If need to change, can I know the dwell time setting.
Thanks.
-
Who’s have read my log file, please tell me how to solve the idle misfiring problem.Thanks
-
This is basemap by attached.
-
Hi, I already on the narrowband o2 sensor and adjust some the fuel setting, result is better thank before. But just now having problem with idelling, there missfire on idle. Can help to check the problem.
-
Ok, thanks Adamw. I will on the lambda mode and test again. Will report.
-
-
Hi, I start the engine today and trigger offset is set to 320 degrees and lock the ignition timing to 10 degrees BTDC by timing light. But I having the problem now, when I tested on the road, the rev rpm only up to 3500rpm only. Something like fuel cut. Can help to check the bace map and log file?Maybe is injector timing problem? Now I’m have install turbo charger and direct spark mode for this engine. Hope can help to solve the problem. Thanks.
-
Ok, I understood and I will try doing trigger calibration. Will report if having problem.
-
Hi, I have complete the wiring, any basemap to support for this model? Now I have installed direct spark. Thanks
-
Hi, finally I received link monsoon, before start the wiring job, I need make sure the trigger wiring. It’s the red wire is connect to trigger 1 ? How about the trigger 2.? Thanks
-
Ok, thanks for you suggested.
-
Ok, thanks Adam, witch type of G4plus is recommended? Now the engine is installed turbo.
-
Hi Simon, thanks for you reply. So I can start the engine with daihatsu copen mode without the crank sensor?
-
-
Ok, I will take later. Thanks Adam
-
-
Hi, may I know this Suzuki G13b engine can install link G4+ ? And can done the trigger setup for this type of engine? Because I need upgrade direct coil on spark plug.
-
Thanks for you reply, i will try in.
-
Thanks for you reply, so what you suggest for tacho output, witch Aux is better. The original tacho is connected to ECU.
-
Hi, i have one of suzuki jimny jdm and swap to suzuki M16A VVT engine with Linkecu G4 plus civic 92-95 connector. I have set my tacho out with Aux 6.
But why my original tacho meter still not working. It's the setting problem or wrong signal. Please tell me how to solve it. Thanks.....
Using Factory Knock Sensor VR4Link/ DSM
in G4+
Posted
Hi Adamw, would you mind sending me how to turn in on for knock setting with stock knock sensor, now using the Evo1-3 g4+ plug in.
Thanks.
Hi Adamw, thanks for you reply. Because evo 1-3 plug in have stock knock sensor is connected to pin 58, I just wanna to know how to turn it on.
Thanks.