Andreasq
-
Posts
15 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Andreasq
-
-
Hello, sorry for slow replay. I did check the cable and no problem, the idle is still "coughing" maybe the problem I get for not running av IACV.
Greetings Andreas
-
I will have a look tomorrow, thanks!
-
-
Hi, I have a problem with rough idle on my rb25. I use E85 pumpgas. I drive without engine idler it was broken when I got the engine so I run without it. Recently cleaned my injectors, fuel filter and new spark plug. The wiring harness is also new, can't find any problems with a vacuum leak either. I drive kelford cams 262/262 without vvt. The problem is the idle on around 850rpm and 2500 even throttle. Do someone have any idea? I will post a logfile later.
Greetings Andreas
-
I did Change sparkplugs and that fixed all the problem. Thanks Adamw!
-
I Will take a look on that, thanks!
-
Hello, i was going to logg my car and My pclink Keep on disconnting me from the software after like top 10-20 seconds. When i hit the throttle is disconnet right away.
The car is a nissan r32 gtst with rb25. Stand alone Link g4+ extreme.
Do someone have any clue whats going on?
Greetings Andreas
-
Thanks to you guys! My car starte and i hade 11kg/cm3 in compression on all 6 cylinderns. The Idle in ruff, but it starter!
-
Thanks guys! I Will look over this! Do someone off you guys in this forum know the clearance before the Piston hit the Valves on rb25det?Jumped 1,5 teeths on intake Side same for exhaust Side. Running 9:0:1 pistons and cams with lift 9.30mm. compression test Will tell me in 2 days. Wish me luck
-
Thanks henryy, i maybe have found my problem, My hks slide cam pullys have moves 20° hopefully my Valves are okey.. 9:01 cp pistons
-
Here comes the config (basemap) and logging. i can see that i get fuel on my Air/fuel ratio on logging. But i can't here it firing and the timing is set to 10 and checked with a Strobe lamp
Greeting Andreas.
-
I Will sure do. Im at work atm, but i Will send those to you in pm. Haven't use a bulb. I have check the sparkplug and i can't smell any e85 in the sparkplug Hole and THE pistons are dry aswell.
-
Hello.
Im about to start my new built engieen (rb25det in r32 Skyline gtst)
Running a Link ecu g4+ extreme. I have set My base Time to 10° and im getting spark, signal at trig 1 and trig 2 and i can see my rpm is around 200. (Vag Short coils)
My injectors are opening when im doing inj test. But when im trying to start my inj wont fire (THE sparkplugs are dry same with the topp of the Piston) running e85 on denso 95500-0830 injectors.
Greetings from Sweden, Andreas.
Rb25 jumpy and anxious idle problem.
in G4+
Posted
I was holding the throttle at 2500rpm, I did some checks in the tune and it running well leen and som other stuff, so a retune is the way