Oneireacing

Attached (I hope this is what you're after!). Please let me know if there's anything else you need. Thanks, Greg Dump - 9-3-20.pclr

Thanks for the reply, ECU is running the latest firmware. I had a feeling that would be the case with the ports, but not sure if there's any other way to check the CAN port is operating correctly? ECU is currently reset to the factory with the tt base tune applied. All I'm trying to do is get the wideband lambda functional before it goes to the tuner for a proper tune. If there's more to it than the install guide, then I'll step away and leave it to the professionals. Thanks, Greg

Hi all, I recently acquired an older Link G4+ TT Link (s/n 24393, one of the red coloured units) and a brand new link CAN Lambda unit. I cannot find the device on either CAN bus with any configuration. I've triple checked the wiring and pin configuration, length of cable, twisted wires but no luck. I recently tried swapping the CAN buses and on Bus 2 (I assume bus 2, closest to the Map input) the laptop cannot connect to the ECU either. Is that a valid check of the CAN port? Any other checks I can do? Appreciate any assistance.