hwilliams

Hey Adam I was wondering if you may be able to provide me with the factory CAN streams that are programmed into the "Audi TT" setting so I can maybe try populating them myself. Seems nothing else is working to get the speedo and tacho working on the TTlink ecu again... Thanks!

Ok. That answers all my questions for now. Thank you so much for all your help!!

Everything was working just fine before I tried to get the CAN Lambda to work and went in and switched to CAN 1 with the Link CAN Lambda selected on channel 1. The AMB engine is stock for this car. Nothing has been swapped except for an upgraded turbo and intake setup, and upgraded fuel system as well. Is it possible we erased the default streams from the ecu?

The CAN Lambda is plugged directly in to the ecu via the expansion port on the side. Its a Link TT extreme plug in ecu. I have tried resetting the ecu and uploading the factory tt map but it does not seem to make a difference. I have reset the car multiple times as well. Last thing I'm going to try is reinstalling the software on my computer and building a new map from that, just to eliminate some more unforseen possibilities.

The coolant temp is working but your right that the speedo no longer works either. map is attached. thank you Zach Quattro.pclr

Sorry I see what it's doing now. When I open up the CAN setup it has CAN 1 selected but it is off. CAN 2 is set on audi tt but the tach will still not work. Does the can streams menu need to be repopulated? I'm wondering if I accidentally deleted the preset streams, or if they are not shown under preset CAN setups like the Audi TT setting.

Thanks for the quick response. Ive tried doing this multiple times now and it seems that even after clicking apply and then ok, and then performing a store. It keeps coming back up as being set in CAN 1 when i pull up the CAN settings again.

Sure can. Thanks! Zach Quattro.pclr

Hi all. Looking for help with my 02 a4 that i have installed a tt link extreme ecu in. I have also installed the optional link CAN-Lambda unit as well. Car has the AMB VVT-i engine . All was going good until I was running the car trying to get things setup when my tach stopped working. I have reset the ecu back to factory settings in case it was something I did but with no luck. It is not a bad cluster or sensor as if I plug in the factory ecu the tach will work fine. Any help would be greatly appreciated!