[Crank and cam trigger issues]

I have updated the firmware to the latest version, still nothing happens on the trigger scope.. I am clicking the capture button while the engine cranks.

Thanks

[Crank and cam trigger issues]

Hi Adam

Thank you for your feedback I really appreciate it.

I have turned off the the engine kill and ECU hold power, trigger 1 and 2 turn green on cranking yet I do not see anything on the trigger scope.

Attached is the latest tune file.

Thanks again

G4+ Thunder SRT 8 RB 011.pclr

[Crank and cam trigger issues]

G4+ Thunder SRT 8 RB 010.pclr

[Crank and cam trigger issues]

Hi 

I am a first time user of the Link Thunder, after using a few other ECU's in the past.

I have fitted the Thunder to a Chrysler Hemi 6.4 L V8, I have everything working Electronic throttle all sensors etc. I cannot get an RPM Signal, there is nothing happening on the trigger scope either. I have checked the wiring from the crank and cam sensors back to the ECU and all is correct, If I connect a separate scope to each sensor I get a scope waveform signal.

Could there be a configuration issue as I have gone through them a few times and do not seem to find a setup issue.

Regards 

Rudi