Aidan99

I am in Brisbane Australia

Surely something has to be faulty

Still says there is error on can status 1, error passive and bus warning error

Just tried that still no luck

Skyline base tune 3.pclx

I Will try an update the firmware again but I already did that. I used the file you sent me I just reinstalled the newest firmware. Still no luck

so have done what you asked and deleted all the ones not in use and still cant find device, i tried all bit rates on the drop down and till no luck.

that makes two of us, I am stumped! I have re plugged into CAN 1 on the ecu so i re set up the settings on can setup to CAN 1. 346100969_skylinebasemap2CANchanges (1).pclx

I have just checked the Bosch sensor an it’s getting warm with just ignition on That’s with the can plugged in

Is that a resistor on the can h and can l wire or just 1. it appears that the little black link can lambda unit is not getting hot anymore ? But it is receiving 12v ign power from the relay to it.

What do you mean I haven’t done a ‘twisted pair or a terminating resistor’ how do you do that I haven’t heard of that before. And I’ll give it ago I did try that a while back but no difference but that’s before I have changed things around. I’ll keep you updated Unfortunately I just swapped the pins over and still no luck.

119.5 resistance

Hey I have just checked the continuity from the ecu plug to the dtm for the can H an can L and it is all good. I also check from one side of the dtm plug to the other side an there all getting continuity for all four wires. Starting to loose my mind haha, could it be faulty canbus

This is after the firmware update. Still so stumped. 63168728922__DA7373EE-1D7F-4C1D-8E80-FC48CE040D53.MOV

No different still can’t find device

Green an white is what I was told was can h and can l from otaku loom that was made for the canbus

skyline base map 2.pclx

What part of the tune do you want to see, or Do you want the whole file

I have a g4x for a r33 skyline. I have tried both an configured to both

Hey, I am having trouble with my link g4x, can lambda connection. I have wired it up all correctly and the sensor is getting warm so I know it’s getting power (also checked with multimeter) but it just keeps saying connection not found when I go to set it up on the laptop. The can h and can L is also getting low voltage power. I go into my runtime values and it says the can is off, so I am completely stumped I feel I have tried everything any help would be much appreciated. Thanks Aidan