V Fenech

Thanks for your reply I will check the switch as you suggested tomorrow and I will let you know....

Hi Adam, have you seen the logs yet please ?

These are the logs where it shows the problem and a copy of the tune r1.llg R6.llg MISFIRE.pcl

Thanks Adam, I used Falling as you said. I have an issue regarding Misfire about 6000 RPM. I noticed in the logs its making ignition cut but the RPM limit is not becoming active, even yhe trigger is 0 count. The RPM limiter is set at 8300 RPM and the limiter range is 300 so the engine is not reaching the limiter. In the trigger 1 the arming treshold is: 3 at 5000 RPM, 3.5 at 6000 RPM, and 4 at 7000 RPM What do you suggest I should look for please ??

I need some advise about the spark edge. I have 2 channel igniter and the Ignition coil pack is MSD part number 8240. Can somebody tell me what I need to use in the spark edge Falling or Rising ??

Thanks Adamw

Is this flex fuel sensor P/N 13507129 compatible with G4 ECU.

I did like Adam advised and it worked Thanks.

Hi, I have a Subaru 2003 STI with G4 link ECU and I want to make the purge solenoid work. I connected the purge wire to C 13 Aux 8 instead of the rear oxygen sensor. I checked it in the Run Time values to check if it comes on with the three conditions that is supposed to work but still it stay Off in the Run Time value. But when I tested it with the test On it shows its On in the Run Time value. Can somebody advise please ?