kazuyaito2002

Thank you to everyone for their advice! !! Online connection with LINK ECU! appreciate! !!

I got a USB-C HUB and tried to connect it. I was able to confirm the LINK ECU for the port on COM5, but it does not go online. Do you need a little more settings?

thank you! It seems that the problem can be solved. I will challenge!

ありがとう！問題が解決できそうです。トライしてみます！

Then, will it be possible to connect HUB to USB-C and communicate? Will programs that improve it be updated in the future?

I initialized my computer to Windows 10, but USB does not respond. You can connect with an old computer. Why?

Hello! My previous PC broke and I bought a new one, but I can't communicate because of Windows 11. What should I do?

こんにちは！以前のPCが壊れて、新しいPCを購入しましたが、Windows 11が原因で通信できません。どうすればよいですか？

Thank you Mach and Adam! It was displayed! Thank you!

Hello! please tell me! I deleted the unused view on the PC link, but I deleted the 3D of the fuel table and could not display it again. I have tried various things, but it is still impossible to display. Two ignition maps are displayed, what should I do?

Hello! Finally AFR EGT setting is completed. Thank you for teaching me a lot! I would like to drive and try various things from now on. If you have any questions, please let me know! Thank you!

How can I change the display from lambda to A / F?

Thank you! Adamu! I tried setting it earlier and it became possible to display it, but I was in trouble because the numerical value was strange! I would like to try it by entering the numerical value that I was told immediately! Thank you! Thank you!

I was able to confirm the analog input. I was able to confirm + 5V with analog No. 10. I was able to confirm the voltage of the A / F EGT. However, it cannot be displayed in the PC Link settings. I don't know which one to set. I don't have enough understanding of my software, so I set it while studying, but I was in trouble.

Thank you! I'll try. I will report later

Hello! Adamw! Send photos!

The Japanese specification EVO8 has 3 couplers, so I am using it for EVO9. This is it. It is a plug-in for 8 and 9.

NO46 is the ECU pin 46, which is GND. this is Do I have to connect?

Hello! I'm a beginner. I have a CT9A8, but I want to input PLX O2 and PLX EGT with the EVO8 plug-in G4X, but it is not displayed. Additional port Volt9 A / F Volt EGT is connected GND is connected to ECU No46 GND. Both O2 and EGT are connected with 0-5V analog output. I look forward to working with you. Volt 10 PLX EGT