Gtr_lee

It’s connected to Temp3, I think the placement maybe the issue then as it’s not in the stock location on the rb26. I have it in a LMA remote T piece as I previously ran 2 sensors instead of 1. The bosch sensor has an adapter on it due to thread size which come with the haltech kit and does not fit in stock location so i just fitted it in the T. I may have to source another adapter and move it to the oil filter housing Even though i have the oil pressure working ok i thinj i have it on the wrong CAL. I believe it’s on the 1000kpa Ti sensor CAL. should i change this to another one?

Took the car out for a drive and realised that the oil pressure was reading fine but the temperature is not right at all. Highest it got even after a good spirited drive was about 40c. Stock gauge was reading around 75-80c the cal is set as bosch NTC which I believe is correct so not sure what’s going on

It was reading the same as the coolant temp for most of the time and then was flickering about 1 degree out. i also tried using a Cal table just to see how that would read but ended up showing -40c for some reason. some of the points on the axis were different so i left them and then interpolated between the points i could accurately fill. what cal table should i of used? the data i got for the sensor was from the link i attached in the previous post

Sorry @Adamw can i bother you with another question. At the same time i fitted the bosch sensor i also upgraded my IAT sensor to the following.. https://bofiracing.co.uk/engine-parts/sensors/intake-air-temperature-sensor-for-standalone-ecus/ I believe this is the same product dahtone racing and prp in Australia sell. in the link software am i right in using the hella 6PT 009 calibration? Thanks

Ahhhhhh i see now! Thanks for the help! No one else i have spoken to could tell me how to do it!

No i don’t think so, is this in the base of the connector where your arrow is?

Hi, Has anyone ever fitted the above to one of their builds? i am having trouble fitting the terminals/pins in to the connector. No matter which way i try and slide them in they just won’t go all the way in and click in to place here is a link to which connector it is.. https://en.forwardauto.ru/catalog/product_bosch_razem_datchika_davleniya_temperatury_77342/