328e46ess

My Bmw e46 328 came to a stop after I added some gauges to see fuel pressure, diffent temps, oil pressure etc. Suddenly the car died and would not start again. I let it sit for a few hours and came back. Now the car does start, but only runs for 5-6 seconds. The car ran perfectly before I startet fidling with the gauges. I noticed that the software on the computer freezes when i try to start the car. I kind of loses the connection to the ecu. Do I need an updated software or have I broken the ecu in some bisare way? I did not save the session I had going on since the car dies. I tried uploading the tune again but still the same issue. I managed to make a few logs before the software froze. Attached you can find my tune and the logs. map BLADE.pclr Log 2022-05-22 5;53;47 pm fuel issue.llg Log 2022-05-22 8;58;41 fuel issue with start.llg

What I posted i 2021 was issues with cabel throttle. I am trying to convert to dbw to get ridd of the issues.

Same car

I have bought everything I need to convert and install M52 dbw. Had a look at all the connectors and pins an most og the pins are taken. Aux 9 and 10 are taken. Those two need to be used in order to install and get the dbw body working. I do not know what is wired in at those locations. Not many An Volt pins available either. Possible to wire the dbw body to different aux inputs, or move the wires that no goes to aux 9 and 10 to other aux inputs? Added pick plug A

See attached tune Olsen e46 328 TS2.pclr

Hi I previously wrote about some throttle issues with my supercharged Bmw E46 328 on hte facebook page. I have done some logging and hopes that someone can give me some guidens. While holding even throttle the pedal starts to vibrate and becomes a bit harder too push down, like there is some kind of resistance. And while idleing the car gives throttle by itself with out me even touching the pedal. I have attached three logs and the fault codes Log 2021-07-23 7_02_09 pm.llg Log 2021-07-23 7_05_10 pm run 2.llg Log 2021-07-23 10_19_09 pm run 3.llg