Slowkid

Thank you Adam for the response. I have actually found some file from earlier post in this community for Thunder ECU, I imported the CAN protocol and play around with it. Manage to get data stream specific to the ECU like EGTs but the reading is NOT displayed as what seen on my PClink. I am not sure if any specific setup on the Data stream is required. Thanks any help is highly appreciated. Thunder G4+ slowkid.pclr Thunder G4+ slowkid with ICONS.zconfig

Thanks ADAM, worked like a charm. what about EGT reading from the ECU, possible to configure?

Hi everyone, I hope somebody in this community can help me with the following issues The ECU is Thunder with the latest firmware update and the Dash is AIM 7 inch MXG 1.2 strada. my problem is 1. The Fuel pressure reading on the Dash is not the same as shown on my PC Link, somehow seems 10x smaller. 2. Are there any pre-configured CAN data stream specifically for Thunder ECU as I would love to see my EGT reading on Dash. Any help highly appreciated Thanks

Thank you sir for the clarification, I have checked the PCB Board version I have it is 1.5 and have purchased the expansion port to tap the Aux 9 and 10 for E throttle motor control, However when I go online attempting to enable the setting in the software(latest PC Link G4+ and latest firmware), Aux 10 is disabled doesnt appear in the menu. I am not sure if this a bug or the software detected this particular Plugin Board I have doesnt not have onboard Ethrottle Controller and the PC Link automatically disable Aux 10 selection. I attached a screenshot of what I meant. Thanks

Hi everyone, I was wondering if anyone can confirm the G4+ plugin for the EVO8 has onboard Ethrottle controller, or do I need to purchase external controller? Tq and best regards

Thank you very much Adam, will look into that

Hi there, I need some advice on this setup, whether or not possible to remove original ECU of the BMW and make gauge cluster and other things on CAN control works and control by the G4X alone. It will be great if anyone have experience on this setup kind enough to share a good start file . Thank you and best regards