R0b
Members-
Posts
9 -
Joined
-
Last visited
R0b's Achievements
-
Well that would make sense, thanks bud. Now i just have to get spark and hopefully it starts, going to try do ignition test tomorrow.
-
I'm sorry about that sir this is the one I'm working with to try to start the car, trying to start it with stock map sensor/calibration. This is the tune with Apexi map sensor. I'm new to Link really appreciate all the help Mazda FD3S Rob.pclx
-
I really do appreciate the help apexi 3bar log.llgx
-
i have it setup like to said 1volt@32kpa 5volt@290kpa with the stock map sensor it shows 100kpa map and 0 bap with key on
-
Thank you for the advice. Key on BAP shows -99.5, Map 0
-
someone tested a apexi map sensor in the states, @0volts shows -14.5psi and @4.9v shows 28.8psi wouldnt a greddy 3 bar be similar, seen 0.5v@0kpa could i set it up similar to greddy. thank you
-
thanks for the reply i can check tomorrow but that calibration to me seems wrong cause 290kpa at 5 volt would make it a 4bar map wouldnt it since has to use 1 bar for vacuum should be -100kpa@0 volts/200kpa@5volt
-
So when i used that calibration and went to calibrate map sensor before starting getting a error, could someone please help with a calibration on this sensor. with stock map sensor and stock calibration it checks out ok. thank you
-
R0b joined the community
-
hey bud just trying to see if that calibration worked out. thanks for the help