TOMMYFD

Thanks Adamw

Can I have a fuel table change after my rotary switch turns over 4th position. The thing I want to do is boost with water meth on 1-3 positions with different boosts on the rotary switch and 4 position and up 3 different boost options with no water meth, my boosts will be on a (x -y) axis no boost table change just changing fuel table over position 4.

PC Datalog - 2022-10-27 9;45;33 am.llgx Firststart090622.pclx

ok tuned my map a bit now everything looks ok but I have no injector duty cycle for secondaries why dont they activate?

Does the iat and charge temp approximation affect idle so much? Because with the old injectors it didnt.

The ve tables on this map are set back to normal when the car doesnt idle. To make it idle it has to go over 65%

PC Datalog - 2022-10-23 11;30;55 am.llgx Firststart090622.pclx

Changed my injectors have all the data given by injector dynamics my settings are all good but my idle jumps up and down from 700-2000 rpm and goes lean. The only way to have a steady rpm is to have extreme numbers in my ve table over 65% and has a steady 2000rpm with good afr. What can I do to get my iddle back. Any help please

Can i attach the tune so you can take a look with what is going on and be sure?

So its just the tune there is nothing wrong this is normal?

The sard where low impedance but since the car came with a PFC it worked fine. After changing to Link we left the injectors not knowing they where low impedance. The car idled ok but leaned out when gas pedal was depressed so we knew something was wrong and found out that the injectors where low impedance. we changed to the id injectors changed all the settings and the car does this now

PC Datalog - 2022-10-23 11;30;55 am.llgx

Thanks guys for information. Today i started the car since changing from my old 4x sard 1000cc injectors to 2x1050 2x1700 cc I put everything in deadtimes, pulse width with adder staged injection everything is correct i think. The car goes lean and idle jumps up and down, the only time i have a steady idle is if I increase my fuel table at the given point to over 65% percent and RPM go up to 2000. What did i do wrong here?

Thanks Adamw!

Thanks alot Adamw. What if I want to add the 3rd table also?

Hey, hooked up my 12 position rotary switch for boost tables and i put position on y axis but what i want to do is change to a complete table using virtual auxilary but it seems I cant understand how its made any help?

Hi guys i just changed my injectors on my rx7 fd and gone with id 1050 primary and id 1700 secondarys. I setup everything the thing that i want to ask is about the short pulse width adder table, should i fill that or shouls i leave them to zero?

So the promblem has to to be on my cluster. Thanks guys

No i got lights but the speedometer and the tacho dont work

Im using a factory cluster

Hi, im trying to get my odometer showing on my rx7 fd but it seems i cant find how to. Can someone help please?

The thing is tha its a cpts sensor i know how to do that on ntc sensor i just gotta splice the +5v and add the resistor between the signal but the thing here is that they have the same +5v and ground with the oil pressure which doesnt need a resistor. will that be ok if i splice the the +5v going to the cpts? Thnks,

Hi, Im purchasing a cpts sensor and since I never wired one before I would like to know the signals to the sensors are both from an inputs? Or is the one for the temp have to be an temp? thanks

Thnks a lot man for your help.

Its a garrett g35-900 with a garrett speed sensor the turbo its a 9 blade