dohctor
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by dohctor
-
-
was there any resolution to this problem? i am having a similarish issue with my PLM 4 bar map sensor on HC96+ . I am using the factory loom to connect to the map sensor .
On link map sensor is on AN volt 1 channel . i have attached my senor config details below (senor type 4 bar)
If i keep AnV1 error low = 0.05, and perform ecu map sensor caliberation . i get a reading of 100kpa which i presume is the error value that has been set. but then get AN volt 1 below error low value
If i keep ANv1 error low = 0 , and perform ecu map sensor caliberation . i get the cabliberation error
Please advise how to resolve above issue or furthet tshoot it
-
HI, Thanks for your response , but i worked it out, i had the IAT plug incorrectly plugged into the knock sensor. (just running pre-checks before i start the motor). picking up correct temp readings now that i have swapped the plugs around
On a seperate note , what to do you mean my attach copy of tune?.. is that a file--> save as and the attach the saved file, or ecu log export (assume the former)
i would like to raise another problem i am having with my map sensor , would like to attach my tune for that
Cheers
-
Hello link team,
requesting troubleshooting steps .
I have a hc96+ connected to b18c1 engine loom for 1996 honda integra sir. All analogue volt and temp senors are showing "OK" status on run time menu. However , while my ect sensor on AN temp2 channel is showing realistic coolant temp of around 26 degrees. my IAT senor on AN temp 1 channel is showing 150 degrees C. worryingly , there is no error codes thrown by the ecu and the temp reading remains at 150 even when i disconnect the IAT sensor from the loom.
Let me know if you need any further info
Cheers
IAT on AN temp 1 reads 150 celcius with with status OK .. no error
in G4+
Posted
thank you for the clarification