its raçing

I just mounted the original subaru gt pulley on the right in the photo, she still doesn't see the rpm, I don't understand

ok so my problem com from me i have crankshaft and camshaft sti so on the left of the photo

okay so I think I'm going to change the vilo pulley and put the subaru gt vilo pulley because currently I have a subaru wrx sti pulley I think the problem comes from

no i have no rpm signal Log 27-04-22 6;43;53 pm.llg

merci pour votre réponse voici la carte de démarrage, puis le capteur de carte je les ai mis en volt5 gnd et +5v de la prise d'extension mais pas de changement dans la carte pour le moment, mon problème est que je n'ai pas d'étincelle au niveau bougie, j'utilise le pignon sti vilo et le capteur de vilebrequin sti, c'est pas pareil que les poulies subaru gt, Subaru WRX V5-6 G4 Storm rui.pcl

adamw here is my config of the tigger IMG_6736_Trim.mp4

adamw thank you for the reponse i am imob on i tried off but nothing changes i still have ecu hold power which remains off here is my ecu

then it is a plug and play wrx 5/6 g4 firmware 4.10.2 my subaru is a gt 2000 with a wrx sti engine and a mix of harness 2000 and wrx, with the oem ecu the car runs. I think I just miss the wire for (the ecu hold power) here is my ecu

hello I am having the same problem on my subaru ecu g4+ v5/6 the ecu stays off (Ecu hold power off) how did you solve the problem?

hello i have a problem on a subaru gt 2000 with an ej20 wrx sti engine i can't get a rpm signal i tried several subaru tiggers but nothing is working, no signal i must be missing information from the ecu can you tell me where the rpm signal is connected to theecu g4+ v5/6 thanks you very much