Amir
Members-
Posts
16 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Amir's Achievements
-
Amir started following Can bus bmw e60 and Bmw s85 v10 tuning Thunder
-
Hello everyone I am planning to run a s85 bmw engine with link ecu thunder I wanted to know if this project has been done before?
-
Hi sir I have bmw e36 M50 turbo runing by link ecu Xtreme X and dash display link 7 inch I want runing speed sensor And I intend to activate traction control I wanted to know if I can activate the sensor on the differential to measure the speed of the rear wheels?
-
Hello Excuse me sir I still did not manage to turn on this engine I was forced to install a separate trigger wheel on the crankshaft pulley I installed a reluctor sensor I did the wiring like this: 1):trigger 1 black 2)trigger 1 white 3) shield ground Trigger wheel is 60-2 now When piston 1 is in tdc position From the point of missing teeth to the sensor, there are 6 teeth in the clockwise direction It means 60 degrees,I am sending you photos of the trigger adjustment tables. Please check and helping me,,According to this information, I should choose trigger offset 60 or enter ref,timing 60???
-
Hello I used this base map But the rpm signal is zero There is no signal I also used another base map I have no signal I also replaced the sensor Complete wiring was checked
-
Amir reacted to a post in a topic: Vq35 hr engine
-
Hello I did the wiring according to this information At the moment I need base map for start engine I used link ecu strom G4+ and I changed trottle to cable manual
-
Hi I doing the project bmw e60 swapped 2jz engine. Oem ecu is code:MS45. do link ecu support the MS45 OEM CAN protocol,
-
Hello sir I need pinout for cam and crank shaft sensor Nissan vq35 HR I searched a lot, but unfortunately I did not find an acceptable reference
-
Amir reacted to a post in a topic: VQ37 engine vhr vvel contoler
-
Hi sir. I wanted to know if AEM smart coil can be started easily and directly with link ecu Xtrem X?
-
Amir reacted to a post in a topic: Vq35 hr engine
-
Amir reacted to a post in a topic: Vq35 hr engine
-
So I have to connect one pin to 12v+ and the other pin to aux, right?
-
Amir reacted to a post in a topic: Vq35 hr engine
-
Amir reacted to a post in a topic: Vq35 hr engine
-
Ok,thank you sir. Yes, change to cable throttle. What should I do to start the vtc system, which output should I use? This sensor 4 wire.
-
Hello,I doing wiring Nissan vq35 hr engine with link ecu Strom, This engine is equipped with a vtc system and I would like a pinout map for starting And the second question is that we have to use an external driver to start the coils or is it started directly with the ecu link.
-
Amir reacted to a post in a topic: VQ37 engine vhr vvel contoler
-
Thank you for your follow-up and response Let me explain more about this project: We installed this engine turbo And swap on another special racing chase We should definitely use ecu stanalone now What do you think is the solution?
-
Amir reacted to a post in a topic: VQ37 engine vhr vvel contoler
-
Thank you for your follow-up and response Let me explain more about this project: We installed this engine turbo And swapped on another special racing chassis We should definitely use ecu stanalone now What do you think is the solution?