Hi,
I tried the first start of the engine after an injector and ECU change (top feed conversion, and ECU changed for a G4X) but I don't have any fuel distributed.
the setup is :
Fuel pump 255l/h Walbro
Injectors Siemens Dekka IV 80lb (840cc) ; 12.5 Ohms
I created a gauge with the injector duty cycle as below
While cranking the max reached by the gauge is 0.8 %
I tested the injectors out of the manifold and they are not cycling meaning I don't have nay fuel coming to the engine. I didn't measure the impedance at the injector but they are supposed to be high impedance.
The deadtimes are coming from the manufacturer's chart so I guess they are OK.
I didn't fill the "short pulse width adder" table.
Here is the base map I am using to start the engine:
Subaru WRX V5-6 Premier demarrage.pclx
Do you have any clue where the issue may come from ? It's like for some reason it refuses to send signal
Thank you in advance,
Best regards,
Yann.