[Evo 9 with X throttle body]

Guys , i have a got a problem with evo X throttle 

Evo 9 with link g4x and evo X throttle

Sometimes appears check engine with traction throttle mistake and i cannot use acceleration pedal( pedal does not respond)

this is the second throttle with the same mistake. What should i do?

does the X throttle the best to use? Or do we have somth better than X? 

[Evo 9 launch control]

1 minute ago, rrob said:

Likely pumping up an exhaust side lifter like most evos do. Which valve springs are in the car?

It has a kit of +1mm valves and springs supertech as i remember  

[Evo 9 launch control]

And one more video

 

 

[Evo 9 launch control]

2 hours ago, Adamw said:

Attach your tune and a log so we can take a look

Will do

 

please see my video 

launch control in active 

and strange  behaviour of my car on idle  after launch 

seems as candles are flooded 

 

 

 

 

 

[Evo 9 launch control]

Guys , i have g4x ecu on my evo9 stock turbo with evo 10 throttle . 

Launch works but i can’t start good. Car fails/pecks when i release the clutch.( car chokes). 

also when i stay on idling  , hold gas pedal (activate launch ) and then release the pedal the car works as with two cylinders (fills with fuel) . 
 

what am I doing wrong?

 

The 2nd question is how to tune ALS?

 

thank you for response 

[Lancer Evolution question]

5 hours ago, Adamw said:

You cant completely swap the whole calibration on the fly, but you can easily switch between or blend between various tables.

For example you can have 2 fuel tables, 2 ignition tables, 2 boost tables, etc, and either switch between them or blend the two tables together based basically anything you like - it might be boost, TPS, a switch on the dash, water injection status etc.  

When i had stock ecu i had the sane fuel cars: octane and octane with meth. So i just needed to switch off engine ,hold acc pedal and thats all! No needed any buttons . Can i release with Link the same? If yes could you please point the way in soft?

Thanks a lot

[Lancer Evolution question]

Hi Guys, i’ve  got Evo9 with Link G4X ecu.

I need to have two programs : octane and methanol. 
is it possible to switch between two programs via  accelerator pedal for example ? Or there is only one way- to install bottom ..