Maneet

And to stream onto 0x600, 0x601, 0x602... I would declare it as the following? To screenshots would supposeldy stream to 0x600, to stream to 0x601 I would change the ID under frame to 1? Also does CAN2 on FURYX have a built in 120ohm resistor? thanks.

Hi all, I have a can bus dash that currently is integrated with ecumaster using there protocol. If I where to create my own can stream CAN Setup this should help avoid me reprograming the dash side to read data correctly? I have attached a screenshot with injector pulse width as an example. Please advise.

Tried it out this morning and it started working.. odd.. Well thanks anyways.

Voltage on the DI pin when the wiper is on = 12V. When the wiper is off = 0V Here is how the DI is set up.

Link FuryX Ecu. Having troubles getting the ECU to read a 12V switch input on DI7 or DI8. I have spliced a 12V switch signal from the wiper stalk. Multimeter confirms a 12V signal on the input wire headed towards the ECU. I have attached the factory stalk wiring diagram, I have spliced to the WHT/BLK wire.