Ümit

Hi Adamw wideband already grounded to engine block and calibration is 0.680 - 1.365

These pictures while engine run

Hi everyone subaru sti link G4x plugin ecu version wrx11x wideband aem 30-4100 wired to rear O2 an volt 7 present fuel is E85 I did already some test and see sensor is working when I remove the sensor socket I see the an volt for 2.36 when I test the sensor full rich and lean also shows correct value but when I start the car at idle couple minutes later lambda shows richer then afr gauge calibration is also ok many thanks inadvance

Thanks adam I can not select the same parameter which is showed on aem dash help file as below on link G4x pc software has below screen I select transmit dahs2pro rest of settings value applied the same but still no signal on my cd7 display I attached also following error codes from dash display Many thanks in advance

Hi I need G4X wrx11x plug and play ecu can setup and wiring info for aem cd7 dash display connection has made ecu main board can H and can L but not receiving