yncz

Unable to change the axis setup in the startup offset table. I want to change the value to the low water temperature side. Is this a software problem?

It was a very good testing method. Increasing the D-gain value improved tracking.(D=50) Conduct long-term tests to check for recurrence of failures. Thank you very much.

The E-throttle system will be shut down and will not be able to run. ECU fault code:75 E-Throttle 1 TPS /Target Error When restarted, the car will run normally. This is the second time a fault has occurred. I think there is a E-throttle control tuning problem. Can you please advise? PCデータログ - 2023-05-27 5;27;34 pm.llgx Mitsubishi EVO 10 G4X Xtreme 20230527.pclx

Checked the indicated starting position. Everything worked fine. We found that the "1" in binary is a good start position. The problem has been solved. Thank you very much for your kindness.

sorry. I'm a beginner and couldn't figure out how to convert the CAN DI 1 to CAN ANV1. I checked the can hex data. Can it be used to solve a problem?

I use G4X XTREME on Mitsubishi EVO X. AC request signal is set to be received by CAN. When the AC is OFF, the AC Request Status is "Inactive" and when the AC is ON, the AC Request Status is "OFF". What could be the reason why the AC request status is not active? Is the setting wrong? Mitsubishi EVO 10 G4X Xtreme.pclx