Tanzeel
Members-
Posts
7 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Tanzeel's Achievements
-
Hi, just bought a Link Can Gauge for my car I wired up the gauge as shown on instructions pin 1 on the Dtm plug going to switched 12v pin 2 going to chassis ground pin 3 going to can L pin 4 going to can H Issue I am having is with the gauge is not powering up at all. I have checked power with my test light behind the gauge plug. Have checked ground wire too. Am I missing something here?
-
done another log both tps and aps aswell PC Datalog - 2022-11-6 7;09;04 pm.llgx PC Datalog aps- 2022-11-6 7;10;30 pm.llgx
-
Yes all done all that, still no action
-
I turned off the relay and moved the blade the an 2 and 3 voltages move under run time value. I also just noticed the e throttle relay is set on inj 8 not aux 8 my tacho is on aux 8 according to my loom pin out file. could you run the e throttle relay of inj8? have attached loom file and another log Old-Loom-Repin.pdf PC Datalog - 2022-11-6 12;56;24 pm.llgx
-
Hi Adam, I can not complete the TPS calibration error number 5 "no TPS main movement" but the APS can be calibrated. supra.pclx PC Datalog - 2022-11-5 2;16;39 pm.llgx
-
Hi, all I am very new to this link Software, I am struggling to setup my DBW using Bosch Dbw pedal and Bosch throttle body. I have checked my 5 reference, ground, and both signals on the pedal. I have checked the same at the throttle I don’t know if this is a map issue or something I have missed. I can’t see any reason why the throttle shouldn’t be actuating when pressing the pedal down. Any help would appreciated!