[Link Can Gauge]

Hi, Adam I got it sorted

My switched feed was tapped into my stereo which was not crimped properly 

Thanks 

[Link Can Gauge]

Hi, just bought a Link Can Gauge for my car 

I wired up the gauge as shown on instructions

pin 1 on the Dtm plug going to switched 12v 

pin 2 going to chassis ground 

pin 3 going to can L

pin 4 going to can H

Issue I am having is with the gauge is not powering up at all. I have checked power with my test light behind the gauge plug. Have checked ground wire too.

Am I missing something here?

 

[Bosch DBW not actuating]

done another log both tps and aps aswell

PC Datalog - 2022-11-6 7;09;04 pm.llgx PC Datalog aps- 2022-11-6 7;10;30 pm.llgx

[Bosch DBW not actuating]

Yes all done all that, still no action 

[Bosch DBW not actuating]

I turned off the relay and moved the blade the an 2 and 3 voltages move under run time value.

I also just noticed the e throttle relay is set on inj 8 not aux 8 my tacho is on aux 8 according to my loom pin out file. could you run the e throttle relay of inj8?

have attached loom file and another log

Old-Loom-Repin.pdf PC Datalog - 2022-11-6 12;56;24 pm.llgx

[Bosch DBW not actuating]

Hi Adam, I can not complete the TPS calibration error number 5 "no TPS main movement"  but the APS can be calibrated.

 

supra.pclx PC Datalog - 2022-11-5 2;16;39 pm.llgx

[Bosch DBW not actuating]

Hi, all I am very new to this link Software,

I am struggling to setup my DBW using Bosch Dbw pedal and Bosch throttle body.

I have checked my 5 reference, ground, and both signals on the pedal. I have checked the same at the throttle 

I don’t know if this is a map issue or something I have missed. I can’t see any reason why the throttle shouldn’t be actuating when pressing the pedal down. Any help would appreciated!