Matt_J

Yes thats what I thought the case was, looks like its version 3.1 so should be good to connect directly across pin6 and sensor ground? Would there be any info around on calibration or setup of the sensor? I have enabled knock control in ecu settings and setup based on what I can find online but cant seem to get any feedback from the sensor or normal engine noise on a log, may not have individual cyl setup correct. Any info on this would be much appreciated. Cheerd

Cheers for the reply, would it need a link knock block or similar to provide the analog input to the knock pin on the Atom?

Hi Im looking at setting up a Bosch/link donut style knock sensor with an AtomX G4X. Can this be wired to the knock and sensor ground pins or will it require a knock block or other device to calibrate and send the correct info to the ecu? cheers!

Thanks Adam, I thought that might be the case, do you have a link to the modification required? Are you referring to a bridge being soldered in place of the internal tacho? I would prefer to mod the cluster than have another device wired in line with the tach.

Just wondering if anyone can help out with wiring up the factory Toyota tacho cluster in a KP starlet to aux output of an AtomX? Have connected Ign - terminal of cluster to aux 4 and tried a test on 240hz and the cluster only sweeps when the indicators are blinking? Is the speedo a high voltage unit and will it require one of those conversion boxes to drive it via an aux output? Any info appreciated, cheers!