Dunkylad95
Members-
Posts
10 -
Joined
-
Last visited
Dunkylad95's Achievements
-
Dunkylad95 reacted to a post in a topic: Crank, No ignition or fuel
-
Perfect, I won't get back over until the weekend to it but I will give that a shot for the idle as I'm fairly certain I have no vacuum leaks I realise my error with the trigger settings I never pressed enter I just clicked confirm on the base setting window. Thanks again for your help Kris
-
Hey Adam, thanks to your help the car finally started, thanks a million ! I have attatched a log file of the first start up and a trigger scope incase you notice anything out of the ordinary but I am delighted so far. Two small issues I am having are the idle speed is quite high , it was at 2200 rpm and with some adjustments of the idle screw i got it to 1400 but i cant get it any lower. Also when i try to calibrate base timing nothing happens and there is a locked icon in the corner, how do i overcome this ?? and do i need the idle to be lower to set the base timing ? Thanks Log 2023-04-10 2;35;50 pm start up.llg Trigger Scope Log 2023-04-10 2;35;23 pm start up.llg
-
Thank you Adam, I will give these changes a try and see how things go, I appreciate your time and knowledge
-
I understand. The tuner who sent me the base map has fuel pump set on AUX8 as fp speed, should this be set to Fuel pump instead ? I have turned off launch control and anti lag as advised. i have also turned off GP Limit 1 as there is no oil pressure sensor on this engine , just the 1 pin oil sending unit. I see an idle valve on AUX2 but i cant see the second one you speak of. Also, should the Fuel pump have a hold time assigned ?
-
I have made the trigger changes as above and will re-calibrate the MAP when I plug back in, thank you. Is there anything else that looks out of the ordinary that would be preventing my outputs from operating ?
-
Hey Kris, attatched is the log file and trigger scope. I did notice while i was over there that my firmware version is 5.6.6.3602 which is older than the version of the base map i was sent (base map version is 5.6.8.3671) if that makes a difference. thanks again Paul Log 2023-04-9 9;15;01 am.llg Trigger Scope Log 2023-04-9 9;14;13 am.llg Trigger Scope Log 2023-04-9 9;16;59 am.llg
-
I am not currently with the car, I will be back there in the morning and attempt to log the data and forward it on, thank you
-
Hello again guys, Attempting first start up on my car and I am coming across an issue where all sensors work in test but none of the outputs seem to be working when I turn the key. All injectors stay off, Fuel pump wont prime, Coilpacks stay off, No trigger signal, No Rpm reading. I have attatched my details below and a copy of the base map if anybody would care to take a look and see what I am missing Base Map 4.pclr
-
Thank you, i will give this a try
-
Dunkylad95 reacted to a post in a topic: Setting Fuel Pressure (ps150)
-
Hey there, hoping to do a first start up on my car running a link G4+ extreme. I am wanting to set fuel pressure using the link ps150 sensor ( I do not have a gauge, just the sensor) I have set the sensor to analog volt 8 input, but what calibration table do I use for this sensor, and how can I view the live pressure in psi so I can adjust it to the required 43.5 psi or is that possible. Your help would be greatly appreciated, Thank You Paul Lawless