arron

Hi just popped back up the garage as it was bugging me about the lambda and found the loom I was sent had the green and white reversed so popped them out and changed them over now I can see it when searched for but not to sure about the final stage where it says please cycle power to the can device. It leaves me stuck on the screen after clicking send ? Also getting slightly familiar with it now I have also managed to add in a rev counter. Any advice would be great thanks. Arron

Hi I’ve re checked the the base timing and got it at -71 which seems a lot closer and ran it up seems a lot better. But waiting on a lead to plug through the coil to be able to do a live running test so could still be a bit out. It does seem better but still hunting a bit and not to good at ticking over. Also noticed that the on screen lambda gauge is not doing anything it has the link can all connected up. I’ve had a bit of a look around the settings but I’m a bit lost. If that is not working would that add to it not running to good. My aim is to find a tuner that is capable of setting this up but would like to get some running in miles before it gets a thrashing. Thanks Arron

hi yes it’s running but doesn’t seem very happy and doesn’t like to rev. I’ve added a picture of some data if you could get any info of that to help me out thanks.

Ok will try over the weekend. Would like to say a big thank you for your help so far and will report back to let you know what’s happening.

Hi yes thanks. I now have a spark so got the timing somewhere near at 90 degrees and noticed that the fuel pump seems to have started to kick in and out. Guess I’m ready to try a first start. Just waiting on another k20 coil as one has gone down.

TriggerScopeLog at 90.llgx please would you check this for me think im somewhere near thanks

Ok thanks very much will try when I finish work. Do you think it should spark when the settings are changed?

TriggerScopeLog 31 08 2023.llgx this looks better

TriggerScopeLog.llgx

Ok great thanks for your help so far I’ll try and attach more info tomorrow.

arrons link.pclx hi only got this at the moment hope it can help thanks also wondering that the fuel pump only runs on test also as i would guess it should run with ignition on . this is all a bit new to me all i know is that it came as a kit ready to go.

Help needed. I have a link monsoon with loom that I have fitted to my mk1 escort to run a Cosworth yb engine. All together and fitted so trying to get it up and running. The ecu has come with a base map. My problems are to set a base timing. I’ve got a timing gun and proved it works by putting the ecu in test mode but when cranking engine I have no spark ?

Hi i need help with my monsoon ecu for my cosworth powered mk1 escort i can get it to spark on spark test but not while cranking any ideas please