Cody M

Unfortunately, no. Have not been able to source one for some reason. But from the looks of it everything matches up pretty much the same on my car at least. I just have to figure out why my crank sensor fries itself. I've started the car twice and after the second time the sensor is done for. I ordered two more sensors but haven't had time to diagnose the problem yet.

Just a little update (been really busy), but I got the new crank sensor in and it is in fact reading a little over 900 ohms. Fired the car up for the first time, in a very long time. Running pretty rough :/ but nonetheless, it ran. Now I have some work to do. Log 2023-09-28 9;18;56 pm - first start.llg

I have an 04 A4 1.8 6spd. I'm not even sure a stock one would help me at this point. I have 1000cc injectors, mafless, stroked, 'boost sensors' are gone..couple other things gone that would probably cause a problem haha I definitely appreciate the offer. I'm still on the hunt for the pin-out with a guy that deals with German cars all the time. If I get it I will definitely send your way. Whether on here or another platform.

Unfortunately, I don't have a stock ECU. I sent mine out to get tuned/flashed and never received it back. So now we here haha. I'm in the same boat basically everything is new in the engine bay and can't wait to fire it up!

I have an 04 A4 and also don't have ignition. I think my crank sensor is the problem. I do have spark through 'testing mode' but nothing, cranking. I've also been looking for pin-outs to compare that's why I asked. It just sounded like you had one. Good luck man!

Do you have a factory ECU pin-out picture by chance. Assuming mine (factory ECU) is the same as yours, and wouldn't hurt to look it over to compare.

Thank you for all your responses this far, I appreciate it. It is the plug-in ECU. Your info is so helpful. I will be checking that, and report back!

This is what I got when running a scope. Its like it doesn't see anything. I have ran a test, I do have spark under testing. I'm most likely missing something simple. I think I did the initial setup correct unless I have to 'turn on' something. haha Trigger Scope Log 9-7-23 4;41;31 pm.llg Trigger Scope Log-2 09-7-2023 7;05;56 pm.llg

Hello all, like the title says I have an 04 a4. It was a 1.8, but currently stroked to a 2.0L. I am fairly new but can navigate myself around and am interested in learning more! Well I just got my build buttoned up, went to prime it and start and I have no trigger signal at all as well as no rpm signal. I'm leaning towards crankshaft position sensor but I should still see trig2 capturing something right? I see absolutely nothing.