loolwut

Yeah that's what I was seeing, was just hopeful that I could make sure my wiring was correct. Guess I just need to get it up in there. Thanks

If I have an ethanol sensor properly wired and connected, but not yet actually in a fuel line, will it show anything that I can confirm it's working, or will it fault because there's no fuel in there at all? Thank you

My saviors! Thank you so much. That is what I missed.

Hmm, thinking about this a bit more. The CAN Lambda module I assume will show up even without a wideband sensor plugged in... I had to extend the wiring for the wideband sensor, I guess it's possible I didn't make a good connection somewhere...

Hello, and thanks in advance to the helpful people on this forum. I have a Link CAN-Lambda module all wired up and plugged in, and have been able to 'find' the CAN device. All good so far. Eventually I want to have dual lambda, but for now just worrying about the one. I have the bit rate set to 1 Mbits/sec, the device ID is the default 950, all the drop downs are set to Lambda 1. I feel like I've been following the directions correctly. Now, I want to see the live values to make sure it's working. When I setup logging for the Lambda 1 values, I dont see anything working. I've waited a bit to let things warm up, I understand the sensor needs to warm up before it starts working. Is there something obvious I'm missing? First time on the forum, first time using an aftermarket ECU. Should I upload my tune file I'm using and/or a log of it running?