Sten123

As described pin 9 gives 3.4V DC to ground but pin 10 gives 0... Is pin 10(Can L) in the wrong hole? Update: I finally understood what the insctructions meant by ECU side lol. Swapped Can L over from pin 2 to pin 4 and now it reads 1.8V DC to ground, but more importantly IT WORKS!! Thank you so much for your help!!

Finally got time to do some work on the car again. I updated the firmware to the latest version and it still does not work. Rechecked the canbus wiring, is it correct I only need canL and canH wired directly from the ecu to the dash? Can't see any problems with them, connection all the way. This is still all the data I'm getting when selecting the Mini R50-R53 mode, is that correct aswell? Seems like I'm missing all the data?

M54TurboLowBoostCan.pclr

Hello! Currently in the process of trying to get my instrument cluster working in my bmw e46. Mainly trying to get the rpm counter and ECT gauge working but no luck so far. First of all, would like to confirm if this old dinosaur is actually capable of doing what I'm asking of it, attatching a picture of the ECU. Assuming it is since it does have a port for it. Anyway I got a Link CANF plug and wired can H and can L straight to the clusters can H and L, is this done correctly? When I load up the Mini R50-R53 can mode it just seems to be empty, so I found a map which Adamw had made for an e46 m3 and copied the values for the RPM and ECT but the gauges are not reacting at all. I do not have an m3, would the ID's be different? The ECT is all the way to the right, same as it was before wiring it in to the ECU so assuming this is because of no signal. Any ideas as to what I'm doing wrong greatly appreciated, obviously it's something right...