Wesdavis243

.

I went ahead and just bridged the wires on the connector and then changed the CAN settings to 350z. Everything is working such as fans and all the dash as well. But I still don't have vehicle speed lol. i attached my tune to see if there is a setting i need to change or if i am looking at the wrong section. I can also do a log if need be. Thanks! after bypass WS CAN module.pclx

I talked to wiring specialties and with there swap harness the ac won’t work if I bypass there CAN module. So I am just going to tap into the front right speed sensor. Do I need to unplug the sensor or can I leave it plugged in and just tap into the wires? Also do I need to run both wires to the ecu to a DI and a sensor ground? When click on the DI to set it up do I just click FR wheel speed and then it will work? Thank you

The Link will also keep my dash working? So basically I just need to bypass there can module.

Just so there’s no confusion I am talking about wiring specialties CAN module that comes with the harness to make the Speedo and everything work. I did set that up in the ecu with the CAN settings in the beginning. So I assume that your saying the actual CAN is not wired into the ecu currently with that harness. Do you have a general idea on the steps on how I would wire the CAN to the ecu? Thanks!

Hello! I have a wiring specialties rb25 Neo swap harness with there can module and running link g4x fury. I just noticed I have no vehicle speed to the ecu. I was wondering if anyone has the easiest way to get vehicle speed. I have no problem tapping into a wheel sensor but I don’t know the settings it would require. It is a 2 wire sensor so I just need to tap into 1 of the wires and run it to a DI on the ecu. Trying to avoid using a gps module. Thank you!