Hi all, I am installing a bosch knock sensor onto the engine permanently for tuning purposes.
Can anyone give me the wiring input/outputs on the DTM pins for the link G4+ knock block so it can be just a plug in and go setup.
Thanks in advance, Craig
Hi all,
I am currently wiring in my G4X storm ECU into my lotus(ish) kit car and looking to wire in variable launch control.
I am planning to use a MSEL rotary switch like this (https://msel.co.nz/msel-2-10-position-rotary-switch-with-straight-boot/).
I already have a clutch switch (as a low switched input) installed as this was how I armed launch on the previous ECU ( megasquirt)
Do i need a separate arm switch on the dash or can i use the position 0 or 1 on the rotary switch to have it not armed?