Flyboy

Thanks! Is there a way to "read" a PCLR file? Or just load it in and go through everything?

Thank you! Some of the data is coming through now...just need to solve for the rest! TP, IAT are coming through. MAP on AN1...not yet...

Thank you! You are correct, it is a G4+. I have been able to make some progress on a few of the sensors, but not yet on the ones that use maps. I'll keep working on it using the built-in help. I did find someone doing a similar build using the same G4+ on a GM LM4 (I'm using a GM L33) and same wiring harness diagram. He sent me his PCLR file. If I load that, will it include all of the settings for the sensors, maps, etc. or do I need something else? Just trying no to reinvent the wheel here as a starting point.

I have a g4+ wire-in that I'm using for an engine build project. I'm trying to get the canbus working to send data to a CAN Checked MFD15 display. I've already wired the can H/L to the display from the ECU, but I'm not getting any data. Does anyone know how I can configure the canbus output form the G4+ so the display can get the data?

No. I didn't know I had to do that. I can't seem to find the manual for the G4X on the website, only the manuals for the G4X plug in manuals. Do you know where I can find that? I only have the quickstart guide. Extreme G4+ Wire in

Hi - Newbie here... I'm using a G4X Extreme on a custom build with a wiring harness from scratch. I'm pretty far from first engine startup, but trying to check my wiring harness. ECU powers up and I connect fine from my PC. I was expecting to see sensor data when connected to the TPS, OP, MAP, Air Temp, etc. However, I'm only seeing static data with fixed values for MAP (85) Oil Temp (90), OP (0), IAT (20). The only value that is changing is batt voltage. I've checked the probes and they are getting voltage (5V). Either I don't understand how the software works (likely) or somehow all these probes have wiring issues. Any help is appreciated!