Currently wiring a G4 thunder with AIM pdm32 and AIM key pad. Currently have the basics setup from Link ecu to aim pdm. But I need to add extra outputs to the pdm for control.
Electric fan, Fuel pump, two stage no2, No2 Purge, No2 bottle heater, Attessa pump on/off, Attessa Solenoid, additional 6 AN voltage inputs for Egt temps. Shifter position.
Happy to set it up my end if they’re a bit of a write up to follow to doing it. Just looking to pin map on the bench before committing to the sealed harness.
regards Mathew