Michael Riedweg

I mesured. Between 2 and 9 I've got +1.6V, and between 2 and 8 it's +3.2V Between CAN high an low I've got 1.5V Seems to me, that the signal from the ECU arrives at the dash. Maybe something is wrong with my dash? I tried now with your software, and still didn't work...

Still on the same point... Have maybe anyone the original pre-setted date from the mxs-strada when it comes new from the factory? I want to try, if it maybe works with this. I don't have any more ideas.

Sorry for late anser. Pictures are attatched. I use the LINK cable to connect the dash with the ecu. I opend the ECU to try the plug on CAN1 and CAN2, but both didn't work. The 12V is connectec temporary, but this is not really a problem. You can see that the dash is workng and I tryed to set some parameters to show me if the ECU is connected. On the TPS (right below) it should show me the status without the engine is running (only with power on the ECU) how wide it is opend, same as the ECU does when I connect it with the LINK software, right? So there you can see now, the 12V is here, but no connection between the ECU and the dash. Link 05.jfif Link 04.jfif Link 03.jfif Link 02.jfif Link 01.jfif Link 07.jfif Link 06.jfif

Thank you! I downloaded and updated the newest firmware to my ecu, but it didn't help. Now I checked all of the wirings, tried on the ECU the CAN1 and CAN2 output with the cable, but nothing happens. Am I right, that usually I should see the dash, when I search on the ECU in the CAN Setup for CAN Devices (picture attatched)? And no, I don't have any CAN faults on the ECU. On the dash I connected the white cable to the CAN High (+) and the blue to the CAN Low (-).

I've got the files with my settings in the attachment. On the ECU I tried with CAN1 and CAN2, 20Hz and 50Hz. Last was 50Hz. Can anyone help me? MXS 1.x Strada 01.03.2024.zconfig Dash Connect 01.03.2024.pclx

Hello everyone I searched in the whole forum but didn't find a anser so I had to start a new topic. Finally I found some time to install my mxs 1.2 link branded dash in my car. Connected the CAN to my Link G4X ECU (Plug in for CA18det Engine) and tried to configure everything. Now, accidentally I may deleted everything what was pre-setted on my MXS and now I don't figure out, how to connect those two (ECU and DASH) together. Ist there a way to download a pre-setting file from Link to load it on the dash again? Or is there a discription for all setups when you want to connect the ECU with the dash? I watched the video from Link in youtube and tried all of these options, but nothing works. -> Settings in ECU with CAN1, choose dash, 20Hz, ID1000... -> Settings in dash with almost every Link ECU I tried (i have 3 diffrent to choose) I really don't know how to set up this and think, it will really be a small problem if someone can help me out... Regards Michael