puller

I'll get them off one of the machines at the shop, thanks!

Haven't posted in a while, not sure why I have to post in the "Guest" forum now when I'm signed in? No big deal. I have two machines with V44's running the 4.9.3 version software and I want to update them to a version that supports timed based boost control. What is the best version to go with that will not change a lot of my parameters? I don't think the 4.9.3 supports time based as we tried it tonight with no luck. Thanks!

One more question. I should be able to configure the timer on when the launch control button is released correct? Then I just set up the the timer in a 2d form and it will give me say 5#s at the release point and then curve it in over a 3 second timer to say 35#'s? Just want to make sure this is doable before taking the time to set it all up! Thank you for the reply!

Can I set up my 3D table using map against time? I see it is one of the selections however it when selected it tells me that I must select 0 only? Timed boost control is a must for me and currently we run 4 of your V44 Ecu's but have to run an external e-boost 2 at the cost of $600 extra to my customers. Is there a way to have timed boost control via curve, step? These are CVT machines so gear selected boost control isn't an option. We are getting ready to order a few more ECU's for projects we have going. Thank you