BhdrAltn
-
Posts
12 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by BhdrAltn
-
-
First of all thanks a lot to paulr33 again. I used his code and tried to adapt to nextion display .
I am not a programmer. What I did serves what I want. Any suggestions to improve the program, speed, qualities are welcome. You could find everything needed attached to this post.
Main Hardware Used ;
Arduino UNO
CAN-BUS Shield V2 (Seeeds Studio)
2.8 Inch Nextion HMIThanks & Regards
vipec nextion digital font.tft VIPEC_ARDUINO_CANBUS_NEXTION.zip
-
The arduino code would be helpful since I am trying to similar thing with nextion screen.
I think , I can adapt the sending data to display section for nextion.
Thanks
-
Hello any update on this project?
Do you mind to share your final code?
Thanks
-
Hello
Is it possible to run bmw economy gauge with vipec v44?
Thanks
-
-
We almost finished . Some little think left . Cap for distribitor , wide band installation and tuning left .
-
From tuning menu chose Runtime values . Under Analog Tab you could see Analog voltages
-
-
Hi
I use 60-2 from E32 M30B35
I have bosch 0280150714 type injector.
M20 map will be helpful ( [email protected] )
This is my car and what i done .
-
Trigger calibration done. Map will be helpfull.
-
Hı I am Bahadır from Ankara TURKEY
I am traying to install V44 on to 1986 BMW E28 M535.
I have difficulties on making trigger calibrtion. Trigger offset and Referance timing in the are locked and I can not enter any value to them in Set Base Time Menu.
Probaly I missed some easy issue but I cound not find.
Any idea or comment will helpful
Regards .
Ps: Is there any body used Vipec on Bmw M30 motor and have base map fot it?
Map for Bmw M30B34
in ViPEC V Series
Posted · Edited by BhdrAltn
wrong font size(still)
Log 11-09-21 7;26;47 pm.zip 05-07-2021.pcl