Jason Sutherland

can you upload your .PCL file?

haha, was just about to say this as its happened to me before.

true, except it will mean stripping the loom back and re-routing the feed wire. found out it called a impulse tacho, common for the 60's and early 70's. triggered by pusles on current rather than voltage.

nah, well not my one, it has a loop wire that you unplug and wrap around the power feed to coil then re connect. im using single coil with dizzi running from link. it needs to replcate a load simular to a coil to make the tacho go. yea i should ask in the uk, just thaught the people at link mite have come across this before.

hey guys, Â i have a MK1 escort with a 6 dial dash. Link g3 with g4 firmware running a turbo sohc2000. question is the tacho had a inductive loop that the power wire to the coil would normally run through. this is how the tacho recieved its signal. is there a way i can replacate this by triggering some sort of solid state relay powering a resistor through the inductive loop? or am i way off the mark. Â Cheers Jason