Link Mad Man

Hi, I have a rover v8 running on a LEM v3 Ecu, I just want to make sure the injector ballasts are ok with out any additional resistors, I and running 4 injectors on each injector drive - 8 total. The Factory resistor box is in place and each resistor is 6.2 ohms and are on the positive feed to each injector, and the injectors them selves are 2.6 ohms. Do I need any more resistors in place, on the drives, the manual shows 1 ohm, should I be putting these in place or is it ok because of the resistor box? Â Thanks, Ryan

Hi, does any one have a setup file/maps for a Linkplus v10, running a b16a (in an 89 integra), stock inj's, cold air, headers/exhaust, U/D pully, exhaust has been converted to a single 3 wire o2 heated sensor Just wondering about the injector settings wakup times etc ,map(zones) sizes, map sensor settings, also a timing map for this motor running a link would also be nice. I do have a wide band so can tune in fuel maps, but would be great to get a .pcl file with inj/maps etc already setup for the b16a, so I can tweek it from there. Thanks Link Mad Man