Anders Reineborg
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Anders Reineborg
-
-
Solved the launch firmware bug yet?
-
so what should we do to solve this firmware bug?
-
Nothing is changed fron last year when it worked, except firmware.
i know at least two others that have the same problem.
they changed to virtual aux to get it activated and i don't want to do that, i want it to work as it was last year.
where should i send my tune to?
-
On the new firmware (june) 2d launch doesn't work, i activate my launch with the handbrake with di3 goin to ground.
i clearly see the di3 being activated when the handbrake is lifted, but the launch doesn't go in.
so i changed to single zone then it worked.
So what should i do to get the 2d work??
and what settings should i have to build much boost at low rpm 5500-6000rpm??
yes i have a big turbo and 2 litre
-
-
-
-
Hi
Â
Well i'm having trouble to get the measuring right in the Ecu
I have Aem failsafe wideband 30-4900
And i'm a little confused of wich wire i should use from the Aem also
White cable says AFR analog output +
Brown wire says Ground analog output -
Â
And the calibration is linear so i use caltable 5
0,5volt = 0,58lambda
4,5volt = 1,23lambdaWhen i use this calibration the gauge in the ems is way off.. Aem gauge reads 12afr and in the ems 18-22afr
I installed a friends Aem 30-4100 and setup it cal to
0volt = 0,66lambda
5volt = 1,37lambdaÂ
with this gauge and cal it show correctly.
Â
But it would be nice if i could use my own wideband instead of my friends
Do you have any suggestions what to do, or shall i sell it, if it perhaps it is not compatible with link?
Launch control 2d
in G4+
Posted
I just mailed the tune to you Simon