Mohsin

unable to configure my aem uego wideband with my link g4+ as i have mentioned this problem in my previous post . this is how it is at the moment wideband configure as analog volt 5 as wideband function lambda 1 calibration cal table 4 low volt is 0.00 high volt is 5.0 error value value 34.464 lambda Cal table is input value A 0.00v input value B 4.25V output units Lambda output value A 0.683 output Value B 1.264 what am i doing wrong its not showing as my aem wideband showing afrs

as i connect it to my link ecu and save the file this error pop ups and the software freezes i tried reinstalling but same problem as i tried the previous version that was working fine then i get back to the new version and getting this error again.

Just updated my pc link software version and now I'm getting this error and the software freezes stops working what's wrong with it any help?attachment below

I'm link g4+ user is there any feature to check how many psi the map can support ??

I just activated launch control set it to 2d table at 4800rpm and set the disarm speed to 10kmph but its still in launch when i m running the car the speedo working fine and the signal wire is originaly attached by default why is it not disarming ? Any help

I have just done with it Thank you all link team I will buzz if need to ask anything Thanks again

gp voltage means gp input ? Just attached a thmbnail

how do i check the voltage for afr ? the wideband unit is grounded to chasis .. should i ground it from engine block as the ecu ? is that u meant?

sorry @Simon i just checked my wideband model it is not 30-4110 .. it is ( 30-4100) DO you think setting will be change so that it will work fine ?

For example? How do i measure the actual voltage ?

alrite it just started working but still calibration issue seems incorrect but i m closed to it just attached the image it is showing afr on my wideband 12.4 but on lambda guage its showing 9.26 please help further.

yes the same wideband i have i didnt understand the point a & b did u mean the anv5 error low and error high ? Just attached a refrence pic what and where i did ....

I am still unable to connect my aem wideband with my link g4+ please help me to configure it properly ....

Wired up my wideband to analog input 5 and yes that was yellow wired activated it from pc link it is asking for values it is aem uego

hello to all Link management members i am just new to link so i am going to bother you little i recently bought link G4 plugin for my 3sgte st205 with extension loom installed the ecu and started the vehicle just need to ask where can i connect extension loom wires ? 1st i have aem uego wideband iam trying to connect it with my link ecu i connected it on volt 7 pin is that fine ? but i m unable to activate it in link software.. 2nd i want to activate antilag for that purpose i would need a switch in clutch for flat shifting ? if yes then which wire will connect to the switch as there should be two wires... i would love to know about the other wires too and where can i use all of them when i needed it ? thank you in advance