[Altezza plugin issue]

on thebase map shown to me the rpm limit and map were both set to rotary and base timing was set to -5 as the ref timing 

cheers ross 

[Altezza plugin issue]

Hi mate a little unrelated to the issue you are having with the can dash issue  but is this the map the car is currently running ?

if so i would be a little concerned as to how a couple if the parameters below were introduced and has any of the can data also been changed  

 but i have had a look thu your map  and noticed a few  things of concern  the limits are all set to rotary only 

also the injector short pulse widths are not correct which will cause al kinds of low speed running issues 

the base timing has been set up using after top dead centre  numbers not btdc

charge correction is also not been switched on which is critical in correct tuning of modeled mode 

regards Ross

[12a turbo rotary flooding on crank]

Hi ive just had a look at your map to will need to pull down the table numbers by about 40 % in the cranking and post start menu then fully tune your fuel maps before going back to your cold start

hey look only twenty years of tuning links and im just a newbie lol  i love this