Jump to content

Enrike2520

Members
 View Profile  See their activity

  • Posts

    11

  • Joined

  • Last visited

 Content Type 

Posts posted by Enrike2520

  1. Ecoboost 1.6 Fiesta ST180

    in G4+

    Posted

    I changed projects however i instaled 3 Force GDI on ecoboost 2.3l and 2.0l i have calibration for spill valve

    The 1.5 is a 3cyl? right? 

    are you sure its going to make it?

    i am curious cause i was thinking of using BMW 1.5 3cyl and with the way The Force GDi is setup for boosting voltage i am not sure it going to make it.

    Maybe Link can confirm<

    Eric 

  3. Ford EPAS CAN message (electric power steering)

    in G4+

    Posted

    Hello everybody 

    i am looking for the the CAN message to enable the EPAS on a Ford Focus ST 2014

    i hooked up a Link Foce GDI on it and for what i know the EPAS need to know the engine is running and maybe the VSS

    the car is no longer have the ABS so i would like to send VSS and Engine speed through the CAN bus.

    we already make a few test with no succes 

    if somebody can point me on the correct message to sent over the CAN

    thanks 

    Eric 

  5. Force GDI boost reached ERROR

    in G4+

    Posted

    I have hooked a Force GDI on a Mustang Ecoboost engine for close to a year now and i had a trouble with it on last week end 

    the car stopped during stage rallye , when we got the car in the garage we found that the speed sensor (hooked on digital input) wires melted on the downpipe ,

    fixed these wires but the car wont start ,,, did plenty of tests and my opinion is that there is something wrong with the ECU 

    No injector triggered and no control on the pump

    short video of wath happen while the engine run with somebody throw some brake cleaner in the intake

    any other idea ?

    Eric

     

  9. Force GDI no output on DI pump driver

    in G4+

    Posted

    tested your suggestion and i got an error befor starting the car (long pulse) i would have to ground the other pin to make it work? so i decided way to diagnose 

    i installed a noid light ,instead of the pump solenoid and i got no pulse att all when the status is active i should have before the error came on ?

    i suspect the driver to be defect i even try in saturated mode (with the noid light )and nothing more

     

    can a firmware update reset a faulty driver?

  11. Force GDI no output on DI pump driver

    in G4+

    Posted

    Hello everyone i just installed a Force GDI on a Ford Ecoboost engine the engine start but run on low pressureand trow an error after a few second saying the DI pump cant reach target and dissabling it.

    I put the delay to the maximum 10sec to try diagnosing it with a scope ,,, no command sent from ecu to actuate the solenoide. 

    i attached the file if you can have a look at it , i have a good 12v to the solenoide , and when i unplug the connector i have an error saying the wiring is faulty so it confirm mi connection is good .

    is there a way to test this output (same as the injector or ignition test)

    thanks 

    Eric Courchesne 

     

    ecoboost injector scaled.pclr

×
×
  • Create New...