Enrike2520
-
Posts
11 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Posts posted by Enrike2520
-
-
Anybody have ever install Force GDI on 1.6 Ecoboost ST180 engine ?
-
Hello everybody
i am looking for the the CAN message to enable the EPAS on a Ford Focus ST 2014
i hooked up a Link Foce GDI on it and for what i know the EPAS need to know the engine is running and maybe the VSS
the car is no longer have the ABS so i would like to send VSS and Engine speed through the CAN bus.
we already make a few test with no succes
if somebody can point me on the correct message to sent over the CAN
thanks
Eric
-
Everything is ok on that side
would you recommand shipping ECU to have it fixed ?
-
I have hooked a Force GDI on a Mustang Ecoboost engine for close to a year now and i had a trouble with it on last week end
the car stopped during stage rallye , when we got the car in the garage we found that the speed sensor (hooked on digital input) wires melted on the downpipe ,
fixed these wires but the car wont start ,,, did plenty of tests and my opinion is that there is something wrong with the ECU
No injector triggered and no control on the pump
short video of wath happen while the engine run with somebody throw some brake cleaner in the intake
any other idea ?
Eric
-
I a 4 lobes ecoboost engine running on Force GDI i can share my tune file so you can compare with wath you have
-
Boom!!!! It works ,,, problem fixed with the new firmware
thanks Adamw
-
-
tested your suggestion and i got an error befor starting the car (long pulse) i would have to ground the other pin to make it work? so i decided way to diagnose
i installed a noid light ,instead of the pump solenoid and i got no pulse att all when the status is active i should have before the error came on ?
i suspect the driver to be defect i even try in saturated mode (with the noid light )and nothing more
can a firmware update reset a faulty driver?
-
Your right the AN Volt was not properly labeled the fuel pressure is on the AN Volt 8
as for the fuel pump control it use a fixed fuel pressure with a mecanical FPR set to 55psi
-
Hello everyone i just installed a Force GDI on a Ford Ecoboost engine the engine start but run on low pressureand trow an error after a few second saying the DI pump cant reach target and dissabling it.
I put the delay to the maximum 10sec to try diagnosing it with a scope ,,, no command sent from ecu to actuate the solenoide.
i attached the file if you can have a look at it , i have a good 12v to the solenoide , and when i unplug the connector i have an error saying the wiring is faulty so it confirm mi connection is good .
is there a way to test this output (same as the injector or ignition test)
thanks
Eric Courchesne
Ecoboost 1.6 Fiesta ST180
in G4+
Posted
I changed projects however i instaled 3 Force GDI on ecoboost 2.3l and 2.0l i have calibration for spill valve
The 1.5 is a 3cyl? right?
are you sure its going to make it?
i am curious cause i was thinking of using BMW 1.5 3cyl and with the way The Force GDi is setup for boosting voltage i am not sure it going to make it.
Maybe Link can confirm<
Eric