phantomgvr4

here is a log. ive gotten a lot sorted out. really the only issue im having now is under light throttle(maintaining speed) it seems to go rich. thanks Log 2018-08-18 12;22;38 pm.llg

I'm to the point now where it's running great except when I start to build boost. No amount of fuel I add corrects it. Wondering if I should try a mbc and see what happens

I haven't messed with either of them. I will give that a shot and see what happens. When you say response fuel is that accel enrichment?

Sequential injection and modelled fuel I believe. I'd have to double check. I'm messing with it now and it's more when I goose the throttle it goes lean. If I ease into it its fine

One step at a time. Slowly getting there. I worked over my table a bit and can now get a smooth rev sitting on neutral. But I put it in gear and release the clutch I go full lean. I wonder how close our setups are? Got a snapshot of your map I could look at?

Ok I will give that a try Will it do the same if it's running rich? Are you running e85?

Ok I have I have everything hooked up correctly and got my idle dialed in. Now my issue is when I let of the clutch completely and use lighter throttle the car is extremely jerky. Use heavy throttle and it runs like a champ. Thoughts?

Pin 4

Ok. I got the ebc wired in and functioning. Next step is wideband. Its wired in the same way I had it with ecmlink but I can get it to work with linkecu. Trying to do the quick tune because it is way rich at idle

Ok. Thanks for the info guys. I will give it a shot and see what happens

Hello everyone. New to link here. Just got it installed in my 92 galant vr4. Everything is working great except for I cannot get link to recognize my boost soliniod. I have the same 3 port turbosmart soliniod that comes with the eboost2 package. I know one wire I run to the ground on the expansion loom. What input do I run the other too. Might it be better to track down the stock soliniod pin? Thanks