Guest |601| Posted March 10, 2011 Report Share Posted March 10, 2011 try to hook up my 6 egt's and 2 afr's need a little help, i pick analogue input in the table i pick egt 0-5 v and wide band respectively but what do i use for the calibration i am using 6 x plx devices egt's and 2 plx devices wide-band afr's thanks Quote Link to comment Share on other sites More sharing options...
rayhall Posted March 10, 2011 Report Share Posted March 10, 2011 For the EGT's Select each volt input as EGT (0-5v) Select each volt input Calibration as Cal 4 (if you are not using this cal for something else) Go to Cal 4 and set the output units to C deg. Set the Input Value A as 0.0 volts. Set the Input Value B as 5.0 volts. Set the Output Value A as what every the C deg value it equals at 0.0 volts. Set the Output Value B as what every the C deg value it equals at 5.0 volts. For the wideband signals. Select each volt input as Wideband Select each volt input Calibration as Cal 5 (if you are not using this cal for something else) Go to Cal 5 and set the output units to AFR. Set the Input Value A as what is the minimum for the PLX. Set the Input Value B as what is the maximum for the PLX. Set the Output Value A as what every the AFR value it equals at the minimum volts. Set the Output Value B as what every the AFR value it equals at the maximum volts. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.